Thursday, March 28, 2024
Fishery

Introduction to Fisheries Ecology

Ecology is often referred to as the “study of distribution and abundance”. One of the first things a field ecologist will want to know about an animal or plant species is: How dense is the population [units of density are number of individuals {or colonies etc.} per unit area {or volume}].

Another important question is: How are the organisms dispersed [The pattern of distribution in space] within the habitat?

In most cases it is impossible to count every individual or plot their location on a map [This would be a census] because of the time, effort or money involved.

So it would be useful if there were some way that we could get an accurate representation of some spatial characteristics of the population without having to map every organism.

By sampling the population we can do this, BUT the sampling must be done properly if we want our representation to be valid. To insure an adequate representation, some guidelines must be followed.

Procedure

General Procedure: To obtain an unbiased estimate of the population, sampling should be done at random or more specifically the sampling should be conducted in such a way that the probability of each individual being selected in the sample is the same.

There are several ways of insuring this criterion is met – or at least approximated. Random numbers are series of numbers such that the chance of selecting, for example, any digit (0 – 9) is equal at any point in the sampling procedure. If the random numbers can be assigned to organisms or to locations in the habitat, they can be used to select the sample from the population.

One way to generate a series of random numbers is to write the numerals 0 through 9 on slips of paper, mix them in a hat, draw the slips out, write the number down, then replace the slip in the hat, remix, and draw again, etc.

A faster and less cumbersome method is to use a random number table. You worked with ways of getting random numbers in the previous lab.

You can use the numbers in the table to select sampling positions (e.g. paces along a trail, GIS coordinates, termite holes in a wall that you have numbered etc.). Most calculators and spreadsheet applications also have random number generating functions,

Procedure for Sampling Zooplankton

Three common methods for sampling zooplankton (shown in the photographs below) are net, trap, and tube. Nets are used most often, yet they have serious limitations in regard to obtaining good quantitative data, especially in nutrient and algae-rich waters.

Nets are conical devices made of fine nylon mesh that are pulled through the water either vertically or horizontally for a known distance. Animals are captured in a vial or mesh-walled bucket at the bottom of the net and then can be rinsed into a storage bottle for counting.

The amount of water from which zooplankton are removed is estimated as length of tow times mouth diameter of the net. However, nets may not actually filter this volume of water. The main advantage to using a net is that samples of large volumes of lake water can be collected quickly.

Read Also : Treatment of Ciliated Protozoan Infections in Fishes

Nets can be obtained with various mesh sizes, depending on whether one wants to collect only the largest zooplankton or the entire size range that occurs in the water.

Introduction to Fisheries Ecology

The most common trap sampler is the Schindler-Patalas trap, obviously named after the two scientists who invented the device. This is a clear plastic box that is lowered to a desired depth in the water column and then quickly closed (upper and lower doors) by pulling upward on the line by which the device is lowered and raised in the water.

This traps zooplankton inside the box. When lifted into the boat, the water is allowed to exit a small mesh net that is attached to the lower wall of the box, and zooplankton is collected inside a sampling bucket at the end of that net.

This device provides a high degree of certainty regarding the actual volume of water sampled, but if the water column is deep, it may take many samples to collect animals from all depths from surface to bottom.

Read Also : The External Anatomy of Cartilaginous Fish

The third method is a tube, made of common PVC or Tygon. A tube is lowered into the water column, and when the bottom reaches the desired depth (near the sediments), a line is pulled to close the bottom with a rubber stopper or other device.

The tube is raised into the boat and the collected water poured through a net to collect the zooplankton.

This device also provides a high degree of certainty about volume of water sampled, but it may not be an effective way to sample large animals that occur at a low density, or animals that can detect and escape from a narrow sampling device.

Nets, traps, and tubes will be used to collect representative during the Zooplankton Ecology course, and students will participate in a critical analysis of these three common sampling techniques.

Counting and Biomass Estimation

Simple counts of zooplankton can be done with a light microscope. For large zooplankton such as Daphnia, which occur at relatively low densities (1 to 100 per liter), the entire sample may be scanned at a low magnification, counting all observed individuals.

For small zooplankton, such as rotifers and copepod nauplii, which occur at high densities (>1000 per liter), it is standard practice to count a known percentage of the sample volume at high magnification, and then multiply by total volume / counted volume to obtain the total number of animals in the sample.

Once you know the number of animals of each species in a sample, density in the lake is estimated as counts divided by volume of water filtered with the net or collected by the trap or tube.

Quantitative Analysis of Plankton: Generally, The counting procedure involves recording the taxa observed and the number of algal units (objects) for each taxon in a known area of the counting chamber. As the volume of sample added and area of the whole chamber observed is recorded, the concentration of each individual taxon can then be calculated.

Counting Procedure

The count should be carried out in the following manner: A low magnification (e.g. x 40 or x100), whole chamber count to pick up large taxa, followed by transect counts at an intermediate magnification (x250), which are helpful to enumerate “intermediate-sized” taxa that are too small for the low-magnification count but too large to be reasonably counted using fields of view at high magnification, followed by a high magnification count (x400 or greater) using fields of view.

This picks up the small taxa. Aim to count 100 fields of view (i.e. about 400 units assuming the recommended sample concentration).

Qualitative and quantitative evaluation of plankton: Replicate plankton samples, each of 50 L, collected from various spots around a chosen river or lake by means of a bucket and filtered through bolting silk plankton net of 50 p,.

The filtrate should be transferred to other bottle and preserved immediately in 1:100 Lugol’s solution. Qualitative and quantitative analysis of both phyto-and zooplankton should be done following drop count method (APHA 1995). Identification of plankton is often made by following Ward and Whipple (1959) and Presecot (1962).

The inundation or saturation of wetland soils by water leads to the formation of anaerobic conditions as oxygen is depleted faster than it can be replaced by diffusion. The rate of oxygen loss in flooded soils can vary depending on other soil conditions, such as temperature and rates of microbial respiration.

In most wetlands, small, oxidized layers of soils may persist on the surface or around the roots of vascular plants, but generally, anaerobic, or reduced, conditions prevail.

In summary, freshwater Fisheries Ecology defines what we have globally, what we are going to lose and mitigate for, and what, given the right tools, we can save. To estimate potential production, the dynamics of freshwater ecosystems (rivers, lakes and estuaries) need to be understood.

These dynamics are diverse, as are the earth? freshwater fisheries resources (from boreal to tropical regions), and these influence how fisheries are both utilized and abused.

Introduction to Fisheries Ecology
Figure: A Wetlands can be part of a continuum between terrestrial and deep water aquatic systems. Source: Mitsch and Gosselink, 1993.

Read Also : Agricultural Wastes Complete Management Guide

Do you have any question, suggestion or other contributions? kindly use the comment box provided below for all your contributions. You are also encouraged to please kindly share this article with others you feel can benefit from this information if found useful enough as we may not be able to reach everyone at the same time. Thank you so much for sharing!

Agric4Profits

Benadine Nonye is an agricultural consultant and a writer with over 12 years of professional experience in the agriculture industry. - National Diploma in Agricultural Technology - Bachelor's Degree in Agricultural Science - Master's Degree in Science Education... Visit My Websites On: 1. Agric4Profits.com - Your Comprehensive Practical Agricultural Knowledge and Farmer’s Guide Website! 2. WealthinWastes.com - For Effective Environmental Management through Proper Waste Management and Recycling Practices! Join Me On: Twitter: @benadinenonye - Instagram: benadinenonye - LinkedIn: benadinenonye - YouTube: Agric4Profits TV and WealthInWastes TV - Pinterest: BenadineNonye4u - Facebook: BenadineNonye

Leave a Reply

Your email address will not be published. Required fields are marked *

error

Enjoy this post? Please spread the word :)

Discover more from Agric4Profits

Subscribe now to keep reading and get access to the full archive.

Continue reading

0
YOUR CART
  • No products in the cart.